Category: Fuselage

I cut out and trimmed the right hand support channel.

I drilled the holes in the attach angles.

I continued to work on fuselage parts today. I had previously made a number of the parts for the rear spar carry through. Today I finished all of the drilling of these parts. I was short the AN3 hardware needed to bolt the pieces together so I need to order these from Aircraft Spruce.

I completed all of the six former clips.

I finished making the bulkhead this morning.

This afternoon, I cut out the blank to make the bulkhead.

I finished up work on the right and left hand mount assemblies this morning. I noticed that I made a small mistake on angles which results in the barb end not being quite as wide as the web but there is still plenty of material around the rivet hole so I don’t see any problems.

I worked on the seatbelt mount assemblies. I made up the two angles and cut out one of the webs. I previously made the fittings for the assemblies. The fittings still need to be drilled and bent but I will work on that next time.